Although printing can manual continue, the fuser laserjet should be replaced for optimum manual printer operation.
Replace the fuser kit and reset the fuser counter before attempting to print.Make sure that there is a proper attachment between manual the device and the printer, and wait for a solid green status light on the user LED on the device.Note If the upper right door does not close, the transfer drum might not be all the way laserjet in the printer.For letter- or A4-sized media, place the top of laserjet the page toward the rear of the printer and the long edge toward the printer.Duplex error check duplexer The printer has detected an error in the duplexer preventing two-sided printing.Note Trays 2, 3, and the optional tray 4 will automatically sense the media size.5 Lift the green guide, remove any media, and lower the green guide.7 Press down on the large green lever on the right side of the fuser to ensure that it is in its proper position.3 Paper, pre-punched media: 500 sheets of 20 lb (75 g/m2) bond.Stkr: close stapler door The Stapler door is open color or it is not closed properly.Remove all media from the top output bin on the multi-bin mailbox.Insert the cartridge or make sure the installed cartridge is fully seated in the printer.The printer control panel displays messages about where jams occur and which doors to open to clear jams.Although printing can continue, the drum kit should be replaced for optimum printer operation. Complete steps 7 through 9 if you experience repeated jams in the fuser area; laserjet otherwise, proceed to step.
4 From the front of the printer, remove any jammed media.Certain control book panel error messages alternate with instructions on accessing the online help system.Load the media type and sniper size specified on the display.See the installation guide included with the transfer kit.Arial, Monotype, and Times New Roman are.S.Install the transfer drum before attempting to print.Use the control panel to select the size and type of media in tray.EN Media Jams 35 To transmission clear jams from the lower right door 1 Open the lower right door.10 Close the front door.Load the media specified on the display, and configure the input tray in the printer control panel.Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project Related manuals 8550, mediafire 8550N, 8550DN, 8550GN, 8550MFP Printer Replacing the Imaging alpenlite Drum 8550, 8550N, 8550DN, 8550GN, 8550MFP Printer to HP Color LaserJet 8550 printer user.These adjustments will give the best quality output, saving manual time and resources. Please upload files up to fi-maxSize select a country).
However, media remains in tray.
See To clear jams from a finishing manual device (the optional multi-bin mailbox, 3000-sheet stapler, 3000-sheet stapler/stacker) on page.